Patriot RSL - Gate Opens Using Transmitter, but Will Not Close Using Transmitter

Patriot RSL - Gate Opens Using Transmitter, but Will Not Close Using Transmitter

LCR Receiver Only

1. The problem is most likely the programming of the LCR receiver (P2 relay is programmed to latch mode)
   
2. On the Patriot control board locate press and hold the “LED Indicator” push button.
   
3. Look in the lower left corner of the Patriot control board and note any LED’s that are on.
   
4. If the “Free Exit/Open Input” is on then the receiver (P2) is programmed to latch mode.
   
5. Refer to this article. How to Disable Latch Mode on the Low Current Receiver
   
6. If this does not correct the problem refer to this article. Patriot RSL - My Gate Will Not Automatically Close
   
7. If problem is not corrected, call the factory for further troubleshooting.