How to Pair a Premium Metal Wireless Keypad to the Receiver

How to Pair a Premium Metal Wireless Keypad to the Receiver

Overview

In this article you will learn how to pair a premium wireless keypad to the radio receiver. The radio receiver is located inside the opener's cabinet. The keypad must already have an access code added in, refer to this article if you haven't already added an access code: How to Add an Access Code to a Premium Wireless Keypad. The code will be entered on the keypad at the same time as a button on the radio receiver is pressed. This requires dismounting the keypad or having a second person to enter the code into the keypad where it's mounted. An example of this process will be provided at the end of the article.

Applies to Part Numbers(s)

  1. 050551

What You Need

  1. Included key to remove the keypad from housing
    1. A second person can be used in place of removing the keypad
  2. A long and narrow tool of some sort (paperclip, tooth pick, etc..)

Procedure

Enter the Access Code and Hold Down the Last Digit

The keypad will rapidly beep once the last digit is pressed. Continue holding the last digit and proceed to the next step.

Press and Hold P1 or P2 on the Radio Receiver Using the Narrow Tool

Use P1 if the desired behavior is to open and/or close the gate.
Use P2 if the desired behavior is to latch the gate open.

Make sure the last digit of the code is being held while doing this step. Once the green LED on the receiver turns on, the receiver should 'click' and the gate should operate, indicating a successful pair. Let go of both buttons at this time. Enter the access code on the keypad to confirm it makes the gate operate.

Example

The code used in this example is "1234#".
After each key press you must move quickly to the next. If you wait too long before the next key press, the keypad will exit programming mode and you will need to start over. We recommend writing down the example below using your own values before beginning the process. This will help you do the process quickly, ensuring the keypad doesn't time out and exit programming.
  1. Enter the access code and hold down the last digit
    1. 1234, hold down #
    2. Keypad will rapidly beep
  2. While # is being held (last digit), press and hold P1 on the radio receiver
    1. Hold down P1
    2. The gate should operate
    3. Let go of both buttons
  3. The keypad is now paired to the gate. Type the code in to confirm it makes the gate operate.