Patriot RSL - My Single Gate Will Not Operate

Patriot RSL - My Single Gate Will Not Operate

  1. Remove control box cover locate the “Open/Close Command” push button and press it to operate the gate.
  2. Press the “Reset” push button located above the “Open/Close Command” button, then push the “Open/Close command” push button to operate the gate.
  3. When pressing the “Open/Close Command” push button, listen for a clicking sound, if click is heard then verify:
    1. Wire harness is connected to the gear motor cable in the battery compartment.
    2. The 15-amp fuse located on the control board is good if not replace it using the spare located on the control board. Also check the dipswitches (3 and 4) for correct switch settings based on where the actuator is connected to the control board (Gate 1 or Gate 2).
    3. If switches are correct, fuse is good, and harness is connected and clicking sound is heard, then the battery needs to be load tested to determine its condition. Charge or replace the battery depending on results.
  4. If switches are correct, fuse is good, and harness is connected and clicking sound is heard, then the battery needs to be load tested to determine its condition. Charge or replace the battery depending on results.
If the two limit LED’s located below the actuator plug connector are both on the operator will not operate. You must adjust the limit switch.