How to Wire the Cartell CP-4 Free Exit Sensor | USAutomatic

How to Wire a CP4 Free Exit Device by Cartell

Overview

In this article you will learn how to wire a CP4 Free Exit Device by Cartell to your USAutomatic gate opener control board. There will also be instructions for wiring other brands. These instructions apply to all current USAutomatic gate openers.

Applies to Part Number(s)

  1. 070305

What You Need

  1. A small flat-head screwdriver.

Procedure

Wiring the CP4 Free Exit Device by Cartell

Info
Use the chart below to determine where to connect each wire.

J2 Terminal Block #
CP4 Wire Color
#1
Red
#2 or #7
Black
#2 or #7
White
#9
Blue
Not Used
Yellow (not used)
  1. Disconnect the J2 terminal from the control board.
  2. Unscrew the terminals listed above.
  3. Insert the wires according to the chart above and tighten the screws.
  4. Plug the J2 terminal back into the control board.