How to Erase All Programming From the Low Current Receiver

How to Erase All Programming From the Low Current Receiver

Overview

In this article you will learn how to erase all programming from the low current receiver. This will remove all keypads and remotes that are programmed to the receiver. Doing this may be necessary when trying to solve issues where the gate activates and runs.

Applies to Part Number(s)

  1. 030205
  2. 030200

What You Need

  1. 2 Long and narrow tools of some sort (paperclips, toothpicks, etc..)

Procedure

Press and Hold P2 Until the Green LED Illuminates

Once the green LED turns on, release the P2 button.

Press and Hold P1 and P2 at the Same Time

You need to begin holding down both buttons while the green LED is still lit from the previous step. If the light turns off before you hold both buttons, start over from the beginning.
After holding both buttons for 2 seconds the green LED will blink slowly 3 times, indicating all programming has been erased.

Confirm the Programming is Erased

Test a remote or keypad that was previously programmed and confirm that it no longer operates the gate. Start over from the beginning if they still operate the gate.